PolarCPC Activator

From AutoPolar
Jump to: navigation, search

PolarVIMA.png

Activator instructions

Read carefully all these instructions before continue with the activation procedure.
In case you have any issue, please go to our oficial website and create a support ticket here. Our support team will kindly assist you as soon as possible.

The activation procedure consists of two simple steps:


STEP 1 (* With original MMI 3G/3G+ unit installed on car)

  1. Switch on car ignition
  2. Switch on your MMI and wait until it starts
  3. Now connect your activator to the car OBD2 port
  4. In the activator a green light will start blinking, simply wait a minute until it stop blinking and keeps on
  5. Disconnect your activator from the car, and switch of the ignition
OBD2.png
OBD2 Port


STEP 2 (* Now remove your original MMI 3G/3G+ unit and install the new MMI 3G/3G+ in your car)

  1. Switch on car ignition
  2. Switch on your MMI and wait until it starts
  3. Now, before connect the activator to the OBD Port, keep pressed the activator push button
  4. Without release the push button, connect your box to the ODB Port
  5. In the activator a green light will start blinking, simply wait a minute until it stop blinking and keeps on
  6. Disconnect your activator from the car, and switch of the ignition
  7. The navigation unit will take a minute to start again due the activator reset it after finish the process
IMPORTANT : It is not a problem if original unit is MMI 3G and the new unit is MMI 3G+


Navigation units currently supported

PolarCPC activator will work ONLY is this navigation units, have in mind before start procedure :

  • MMI 3G Low
  • MMI 3G High
  • MMI 3G+ Low
  • MMI 3G+ High